15
REAR
WHEEL
REMOVING THE BEARINGS
To remove the bearings you’ll need the following tools:
• Bearing Removal Tool (T1/T2/T3)
• 1x Plastic Presshead (T6)
• Large Spacer (T9)
• Small Spacer (T8)
Remove the freehub and hub cap from the
hub by pulling it off the axle.
Remove the freehub spacer from the axle.
Pull off the non-drive side hub cap by hand.
Place a small threaded plastic presshead (T6)
on the bearing removal tool (T1&T2) and insert
the tool into the axle from the drive side of the
hub.
Place the small spacer (T8) on opposite side
of the hub and screw on the bearing removal
tool handle (T3).
Gently tighten until the bearing is released.
Take the hub axle (11) turn it around and place
it into the non-drive side of the hub.
1
2
3
4
5
6
7
