User Manual
Scion Tech
SC08.MX2000
Tel: +44 (0) 1635 862484
www.scion-tech.co.uk
Page 7
7. Installing the Encoder (Transmitter)
Note:
To ensure adequate ventilation and to prevent overheating, make sure all cables and other
materials are not obstructing the ventilation vents and the transmitter is not placed on another product
that produces or radiates heat.
Connection
Functions
HDMI In
HDMI input from source
HDMI Out
Looped HDMI output for local sink device
Audio In
Analogue stereo audio input, software selectable in receiver
settings
Audio In / Out
Analogue stereo audio input embedded in HDMI signal or output
from looped HDMI input, software selectable
RS232
Full Duplex RS232 data can be sent to an individual receiver or
broadcast to many receivers. Also used for firmware upgrades,
switch (7) selectable
USB
Host USB 2.0 for KVM function.
10G LAN
Ethernet connection between a single transmitter and receiver or
connection to 10G Ethernet Network
Fibre
Optical connection between a single transmitter and receiver or
connection to a 10G Ethernet Network
IR Out
Infra-Red signal output, IR emitter cable
IR In
Infra-Red signal input, IR sender cable
Connecting Encoder (Transmitter)
1. Connect the HDMI cable to the
HDMI In
port and the source device, a premium quality HDMI
cable should be used for 4K resolutions.
2. (Optional) Connect the HDMI cable to the
HDMI Out
port and the sink device, a premium HDMI
cable should be used for 4K resolutions.
3. (Optional) Connect the stereo audio cable to the
Audio In
port and the audio equipment using the
3-pin Phoenix terminal provided. Ensure the po/- connections are correct as incorrect
connections may result in damage to the transmitter or the audio equipment.
4. (Optional) Connect the stereo audio cable to the
Audio In/Out
port and the audio equipment
using the 3-pin Phoenix terminal provided. Ensure the po/- connections are correct as
incorrect connections may result in damage to the transmitter or the audio equipment. The
In/Out function is software selectable, see SC08.CTL200 user manual.
5. (Optional) Connect a USB cable to the
USB
port and the host device.
6. Connect a CAT6A or better quality patch cable to the
10G LAN
port and the 10G Ethernet switch.
7. (Optional) Insert a SFP fibre module in to the
Fibre
aperture and then insert the fibre connector.
8. (Optional) Connect the IR emitter to the
IR Out
port and position the emitter in front of the source
device IR window for remote end control.
9. (Optional) Connect the IR receiver cable to the
IR In
port and position the receptor in sight of the
IR remote.
10. Connect and power the transmitter using the 12V/2.5A power adaptor supplied.
