SAFETY
READ ALL INSTRUCTIONS BEFORE USE. FAILURE TO
FOLLOW THESE PRECAUTIONS COULD RESULT IN INJURY TO
YOURSELF AND OTHERS
1. Use the steam bath on an individual 15A mains outlet
only. DO NOT OVERLOAD THE CIRCUIT.
2. Ensure that the equipment and the power supply cord does not
come into contact with hot surfaces.
3. This unit is only to be used by properly trained laboratory staff.
4. If the supply cord is damaged, it must be replaced with a new
cord assembly available from the suppliers agent.
5. Use only earthed outlets matching the serial plate voltage.
6. Have equipment installed by a qualified personnel in accordance
with local codes and ordinances.
7. Use equipment in a flat level position.
8. Do not operate if equipment has been damaged or is malfunc-
tioning in any way.
9. These units are designed to run only on alternating current
(A.C.) DO NOT CONNECT TO DIRECT CURRENT (D.C)
WARNING
Electric Shock Hazard.
Keep water and other liquids from entering the inside
of the equipment. Liquid inside the equipment could
cause an electrical shock
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical shock.
Do not use equipment if power cord is damaged or has been modified
Part
No.
1
RING KNOB
2
CENTRE RING
3
65MM RING
4
85MM RING
5
105MM RING
6
CABLE GRIP
7
POWER CORD
8
TANK ASSEMBLY
9
STEAMBATH INLET CONTROL
10
STEAMBATH LEVEL CONTROL
11
ELEMENT 2000W 230V
12
6 STATION STEAMBATH TRAY
13
SAFETY CAP
14
SAFETY FACIA
15
PILOT LIGHT
16
THERMOSTAT
Description
MODEL : 6 STATION STEAM BATH
MODEL CODE : 401
