6
ROTATE/ROCK
Enviro-Genie
comes equipped with a magnetic
platform that is used for rotating and rocking.
Installing/removing the magnetic platform is easy,
but may take a few times to get used to. Try the
following technique:
Install the magnetic platform by first unscrewing the
lock shaft until the end of the lock shaft is flush with
the right hand sidewall of the inside of the chamber.
Grab the magnetic platform with the label side up,
so that you can read the label. Hold the platform in
the chamber and insert the hex shaft on the left
side of the chamber into the hex hole in the
magnetic platform. You may need to rotate the
platform slightly to align the shaft with the hole.
Now hold up the right side of the platform, while
depressing the blue lock release. Screw the lock
shaft into the hole in the magnetic platform making
sure the blue lock release is depressed. When the
lock shaft is screwed all the way in, let go of the
lock release.
To remove the platform, reverse the above
procedure.
To select rotating mode:
1. Press the lock release.
2. Shift the magnetic platform to the right.
3. While shifting the platform right, release the
lock release and line up the hex shaft to
engage the lock shaft properly.
4. The platform will lock in place when it
reaches the correct position.
To select rocking mode:
1. Press the lock release.
2. Shift the magnetic platform to the left.
3. While shifting the platform left, release the
lock release and rotate the platform to line
up the pin and the pin slot in the end of the
platform. Shift the platform onto the pin.
4. The platform will lock in place when it
reaches the correct position.
