Schwinn 700IC, Assembly Manual / Owner'S Manual, Page: 15 / 32

15
Shoe Clips (Cleats) – earlier version
Note: The shoe cleats fit both the right and left Pedals.
Tools needed: pliers, 4mm hex key
1. With a pair of pliers, pull off the rubber cover to expose
the cleat mounting holes on the bottom of the cycling
shoe.
Note: This step may not be necessary, depending on the
type of shoe.
2. Remove the sockliner and put the cleat nut in position
over the oval holes inside the shoe.
Note:
This step may not be necessary, depending on the
type of shoe.
3. From the bottom of the shoe, put a cleat in position over
the cleat holes and then a cleat adapter. Be sure the
single arrow on the cleat points toward the toe of the
shoe. Tighten the cleat mounting bolts (2.5 N·m).
4. The cleat has an adjustment range of 20mm front to
back and 5mm left to right. Practice engaging with the
Pedal and releasing, one shoe at a time. Readjust to
determine the best cleat position.
5. Using a 4mm hex key, fully tighten the cleat mounting
bolts (5 – 6 N·m).
4 mm
SR-168