Schweitzer Engineering SEL-351P, Quick Start Manual

Page: 523 / 674

Date Code 990215 Serial Port Communications and Commands 10-39
SEL-351P Manual Técnico
=>TIM 23:30:00 <ENTER>
23:30:00
=>
TRI Command (Trigger Event Report)
Issue the TRI (Trigger) command to generate an event report:
=>TRI <ENTER>
Triggered
=>
If the serial port AUTO setting = Y, the control sends the summary event report:
RECLOSER R1 Date: 02/02/98 Time: 12:57:01.737
FEEDER 2101
Event: TRIG Location: $$$$$$$ Shot: 2 Frequency: 60.00
Targets: 11000000 10000000
Currents (A Pri), ABCNGQ: 235 236 237 0 2 0
=>>
See Section 12: Standard Event Reports and SER for more information on event reports.
Access Level E (EZ) Commands
Access Level E commands primarily allow you to test the battery and set EZ settings and global
EZ settings. All Access Level 1 commands can also be executed from Access Level E. The
screen prompt is: =+>
BTT Command (Battery Test)
You can use the BTT command to view the results of the last battery discharge test, and the time
remaining until the next automatic battery discharge test or you can force an immediate battery
discharge test. The command format is:
BTT x
where: x is blank or “ NOW ”.
If no other parameters are entered with the BTT command, the control checks the status of the
battery charger board by looking at the BCBOK Relay Word element. If this element is not
asserted, the battery charger board has failed and the control responds:
=>>BTT <ENTER>
Battery Charger Board FAILED
=>>