12
Learning function setting
1. Turn on the equipment you want the remote to control and point the
remote toward to it.
2. Press and hold the [SET] and [DEVICE] button simultaneously until the
LED keeps on. Then release both of them.
3. When the LED keeps on, press the [LEARN] button once, the LED will
fl ash once and turns on.
4. Point the target equipment’s remote at our remote’s learning eye
(2–5cm distance).
5. Press the corresponding button on our remote once and release, then
press the corresponding key on the target device remote, if the LED
fl ashes twice on our remote, it indicates that the code was successfully
learned and saved.
6. If you need to learn others button code, please repeat the step 2–5.
7. Press [LEARN] button to exit the learning setting mode, the LED turns
off.
NOTE:
If the LED fl ashes 5 times and still turns on, it indicates the code was not
learned. Please repeat step 2 – 5 again.
Any function button can learn the new code to replace the previous code
except [DEVICE], [SET], [LIGHT], [LEARN], [POWER] button.
NOTE:
If no key is pressed for 30 seconds, it will exit and return to the normal
mode.
Clear all learned key
1. Press and hold the [SET] and [DEVICE] button simultaneously until the
LED keeps on. Then release both of them.
2. Press and hold the [LEARN] button until the LED fl ashes two times and
turns off. It indicates that all the learned key is clear and back to the
normal mode.
