Assembly
44
03.00|WDP-5X |en
WDP-5X-ASM 99-70-Ø36-M
The WDP-5X-ASM 99-70-Ø36-M compensation module in
connection with the SPC-ASM 36 direct clamping pin workpiece is
intended for individual height adjustment to the workpiece. It
forms the flexible change interface to the workpiece or the
clamping pallet. A cylindrical direct clamping pin can be fixed with
this up to a certain extension limit.
The clamping function of the clamping system is driven manually
using rotary movement on the actuator screw on the side of the
housing. The clamping system can be operated by means of a
hexagonal screwdriver (angled pin wrench). The clamping force is
initiated according to the precise torque specification using a
torque wrench. No air supply is required for operation of the
clamping system.
This compensation module satisfies the clamping and holding
function for flexible workpiece support. For positioning in the
plane of fixation, gauge tolerances for the reference clamping
areas can be compensated. At a right angle to the clamping slide
axis, support is guaranteed without angle compensation to the
table clamping. This compensation module can be used several
times in the entire clamping structure. Several clamping pillars can
be loaded with this compensation module. At least two clamping
pillars in the system structure must be fitted with a clamping pin
with centering function such as VERO-S SPA 40 (centering pin) and
a VERO-S SPB 40 clamping pin with sword function.
Activation of the "Workpiece monitoring system" function is not
possible.
5.3.8
