Assembly
01.00|NSL mikro 50-13 1425873|en
19
Aligning the clamping station
The clamping station can be aligned with loose T-nuts along an
aligning groove on the machine table. At least two T-nuts offset
lengthwise are provided and their size is matched to the aligning
groove on the machine table. The T-nuts are not included in the
scope of delivery of the clamping station.
Alignment using T-nuts
Mounting the clamping stations
Flatness and distances
In order to assemble the clamping station, the clamping surface
must have a flatness of ≤ 0.02 mm (based on the entire support
area of the clamping station). The clamping zone must have
sufficient rigidity in order to ensure the relative flatness of the
clamping modules. If several clamping stations are installed that
are linked, it is important to ensure that the flatness and height
deviation of the locating surfaces from module to module (based
on a 50 mm gauge for bore holes) is
≤ 0.02 mm. The gauge
deviation between the separate clamping stations must not
exceed ± 0.015 mm from module to module.
4.2
4.3
