Maintenance and care
34
01.00|KSH3, KSH3-LH, KSH3-F |en
Adjustment of pneumatic jaw end position monitoring
Jaw 1: monitoring open jaw position
• Move base jaws to OPEN position.
• Screw the set-screw (61) into the bore hole o up to the stop
and then unscrew it again by a few turns.
• Slowly screw the set-screw (61) into the bore hole oo until the
differential pressure sensor emits a switching signal.
• Hand-tighten set-screw (61) in bore hole o.
• Screw set-screw (63) in both bore holes and hand-tighten.
Jaw 2: monitoring closed jaw position
• Move base jaws to CLOSED position.
• Screw the set-screw (61) into the bore hole oo up to the stop
and then unscrew it again by a few turns.
• Slowly screw the set-screw (61) into the bore hole o until the
differential pressure sensor emits a switching signal.
• Hand-tighten set-screw (61) in bore hole oo.
• Screw set-screw (63) in both bore holes and hand-tighten.
