Assembly
40
04.00|0889132_ROTA TB2 / ROTA TB2 LH |en
Mounting with 2-part clamping ring (D.R.M.B.)
It is possible to clamp the distributor ring to the machine by means
of a 2-part clamping ring onto a rigid collar (at least 8 mm wide). In
this case the distributor ring is clamped radially to this collar by
means of two screws. The height of the clamping ring must be
designed according to the chapter “Mounting with
bracket”.
During assembly this 2-part clamping ring is first screwed to the
threads of the distributor ring. Then the entire assembly is
clamped to the rigid collar of the machine. For fastening the chuck
with a bayonet or camlock the clamping ring should have a cavity
in order to access the flanged nuts or clamping cams with the
corresponding wrench.
NOTE
The distributor ring must be aligned to the chuck outer diameter
to achieve a radial and axial runout tolerance of at least 0.1 mm.
Radial runout test
5.2.2
