Maintenance
38
03.00|1341130_ROTA NCR-A |en
Maintenance
Maintenance intervals
Lubricating the greasing areas:
Lubrication interval Demands
every 100 hours
normal / use of coolant
every 25 hours
high / use of coolant
after 1200 hours or
when needed
Full cleaning with disassembly of chuck
depending on type of contamination and
quantity
Disassembly and assembly of the Chuck
The item numbers specified for the corresponding individual
components relate to chapter drawings.
The lathe chuck must only be disassembled once it has been
uninstalled.
(See chapter "Mounting the chuck to the machine"
For chuck sizes 190 / 225
•
If present, remove top jaws.
•
Remove screws (item 24) and take off the intermediate piece
(item 14) connected to the base jaw including the sealing
elements (items 17/22).
•
Remove screws (item 39) and take off the cap (item 34). For
this purpose, first move the piston to the "closed" position.
•
Remove the screws (item 61) and take off the mount (item 7).
The mount (item 7) can be pushed off the chuck body (item 1)
from the rear with the suitable screws (screws not included in
the scope of delivery).
•
Remove the six levers (item 6) together with the bearing seat
(item 8) from the chuck body. To do this, there is a bore hole on
the side of the bearing seat in which a removal tool can be
inserted.
•
Push the six base jaws (item 2) radially outwards to the stop
and push the piston (item 3) out of the chuck body (item 1).
•
Slide the base jaws (item 2) radially inwards until they can be
removed from the chuck body (item 1).
7
7.1
7.2
