SCHUNK RCV, Assembly And Operating Manual

Page: 31 / 44

Troubleshooting
7.4 Residue on the workpiece after deburring
Possible cause Corrective action
Feed rate not set correctly. Readjust feed rate.
Tool is worn out. Change tool
Motor bearings are worn. Change motor,
Changing the motor [ } 35].
Tool is not suitable for the
workpiece. Select the tool that matches the
properties of the workpiece.
Too much material is being
removed. Check process parameters,
reduce infeed, reduce air
pressure for compensation,
perform machining in several
passes.,
Operation [
}
28].
Workpiece is approached too
fast or at an incorrect angle.
Tool clogging with material. Use another tool, e.g. with
fewer teeth.
7.5 Tool blocked during the milling process
Possible cause Corrective action
Insufficient or no compressed air
supply. Check compressed air lines.
Check that the pressure valve is
set to 6.2 bar. Pressure must be
maintained while the spindle is
running.
Tool not mounted correctly. Fasten the tool in the collet
chuck.
Workpiece is approached too
fast or at an incorrect angle. Check process parameters,
reduce infeed, reduce air
pressure for compensation,
perform machining in several
passes.,
Operation [
}
28].
Motor bearings are worn. Change motor,
Changing the motor [ } 35].
31 02.00 | RCV | Assembly and Operating Manual | en | 1453513