SCHUNK PSH 22, Assembly And Operating Manual, Page: 29 / 36

Maintenance
10.00 | PSH | Assembly and operating manual | en | 389331
29
7 Maintenance
7.1 Notes
WARNING
Risk of burns through contact with hot surfaces!
The product can heat up considerably during operation. Touching
hot surfaces can cause burns.
•
Do not touch hot surfaces.
•
Let them cool down before working on the product.
•
Wear appropriate safety equipment.
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
7.2 Maintenance intervals
NOTICE
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
•
Reduce the lubricant intervals accordingly.
Interval (million
cycles)
for PSH 22 - 52 Maintenance work
2 Treat all grease areas with lubricant,
Lubricants/Lubrication points [
}
29]
Oil or grease bare outside steel parts,
Lubricants/Lubrication points [
}
29]
2 Clean all parts thoroughly, check for damage
and wear, if necessary replace seals and
wearing parts,
Assembly drawing [ } 32]
7.3 Lubricants/Lubrication points
SCHUNK recommends the lubricants listed.
During maintenance, treat all greased areas with lubricant. Thinly
apply lubricant with a lint-free cloth.
Lubricant point Lubricant
Metallic sliding surfaces microGLEIT GP 360
All seals Renolit HLT 2
Bore hole at the piston Renolit HLT 2