Technical data
18
06.00 | NSR-A | Assembly and Operating Manual | en | 389722
3 Technical data
3.1 Basic data
Designation
NSR-A
100
160
Max. bending moment Mxy
*1
75 Nm
*2
600 Nm
*3
Max. bending moment Mz
*1
200 Nm
1,600 Nm
Locking force
4.0 kN
15.0 kN
Pull-in stroke
0.3 mm
1.0 mm
Repeatability [mm]
< 0.005 mm
< 0.02 mm
Actuating pressure
6 bar
Minimum pressure to unlock
3.5 bar
The operating pressure must not fall below 5 bar
Installation position
Any
Operating temperature
15°C – 60°C
Required level of cleanliness
IP 30 in accordance with DIN EN 60529
Noise emission [dB(A)]
≤ 70 dB (A)
Pressure medium
*4
Compressed air,
compressed air quality in accordance with ISO
8573-1:6 4 4
*1
max. torque when fastening the clamping pin with cylindrical screw M8 with NSR-
A 100 or M16 with NSR-A 160 – DIN EN ISO 4762/12.9 and full support on the
module flat surface.
The directions of force for the maximum permissible torque are shown in the
illustration in the "Coupling Interface" chapter
Coupling interface for NSR-A 100 and NSR-A 160
*2
Alternatively,
the clamping pin can be screwed to the pallet or device using an
M6
screw. In this case, ensure that the maximum bending moments are reduced to 50
Nm. An
M8
screw is the
preferable
option.
*3
Alternatively,
the clamping pin can be screwed to the pallet or device using an
M12
screw. In this case, ensure that the maximum bending moments are reduced to 400
Nm. An
M16
screw is the
preferable
option.
*4
A
separate maintenance unit
must be used for the air supply. The pallet change
system is prepared for use with
non-oiled compressed air
.
Maximum clamping cycles with NSR-A 100, NSR-A 160
Warranty and maximum clamping cycles
Length of warranty
24 Months
Maximum clamping cycle number
500 000 Cycles
More technical data is included in the catalog data sheet.
Whichever is the latest version.
