_________________________________________________________________________________________
XND.00041.002_B – 05/2022
35
Disasembly / assembly of the spindle
6.2
Both carrier jaws (1) must be clamped and the rear lock (5) released.
Both support jaws (1) must be clamped.
Turn the spindle (2) until the pull rod extension (3) is pressed out of the support jaw.
Remove the pull rod extension (3).
Place screwdriver in groove (4) and pull the spindle (2) out of the support jaw.
The procedure can also performed by released the lock (5) of the spindle (2) and pushing the
spindle (2) out first.
Cleaning the spindle
6.3
Unscrew the spindle completely.
Clean and lubricate with high pressure grease.
When assembling, make sure that the seal is seated correctly.
Stroke limitation
The spindle is completely encapsulated and the maximum stroke is marked (3).
Important:
The thread must not be turned above the limit line marking (3), as a spindle that is opened
too far can break out during clamping.
