_________________________________________________________________________________________
schunk.de
XND.00021.005_A – 10/2018
26
Note on the wiper (pos. 070)
It is possible that, during dismantling, one of the wipers (pos. 070) is partially or fully pulled
with the carriage over the spindle thread. In that case, the wiper has to be carefully re-inserted
on the inside with the spindle over the thread.
To do that, it is recommended that a thin-walled mounting sleeve (Y) be used to slide the
wiper over the thread.
Dimensions of mounting sleeve (Y)
Internal Ø 22.5 mm / external Ø 24.5 mm / depth T 135 mm
Schematic diagram:
Important:
The high degree of precision of the KSC is achieved using a processing step while
it is mounted.
The components of different vices must not be interchanged.
This is imperative in order to ensure the consistent central position of the system
and the fitting of the guide between the slides and tool body.
Further dismantling by the user is not permitted but can be carried out by the
manufacturer or an authorised service agent.
Non-compliance with this rule invalidates the warranty.