SCHUNK KGG 100, Assembly And Operating Manual

Page: 35 / 52

Assembly
5.3.9 Mounting the magnetic switch MMS 22-IOL
CAUTION
Risk of damage to the sensor during assembly!
•
Observe the maximal tightening torque.
NOTE
If there is no T-nut available, slide the sensor according to
dimension I1 into the groove (2),
Setting dimensions for magnetic switches [ } 24].
1. Turn the sensor (1) into the groove (2).
OR: Slide the sensor (1) into the groove (2) until the sensor (1)
stops at the T-nut (3).
2. Mount the sensor (1) using the set-screw.
Tightening torque: 10 Ncm
3. Adjust sensor (1), see Translation of Sensor Assembly and
Operating Manual.
35 17.00 | KGG | Assembly and Operating Manual | en | 389166