SCHUNK JGP-P, Assembly And Operating Manual

Page: 52 / 68

Maintenance
52 02.00 | JGP-P | Assembly and Operating Manual | en | 1469637
15. Insert cylinder piston (8) into the housing (2) and while doing
so, observe the installation position of the
magnets,
}
7.6 [
/
55] .
16. Tighten screw (6). Secure the screw with medium-strength
threadlocker.
Tightening torque:
}
7.7 [
/
56]
17. Insert flat gasket (5).
18. Fasten the cover (4) with the screws.
Tightening torque: } 7.7 [
/
56]
19. Fasten the cover (10) with the screws.
20. Mount product onto the system/machine.
21. Connect all compressed air lines.
7.5.2 Replace seal (variant with gripping force maintenance "O.D.
gripping")
WARNING
Risk of injury due to spring forces!
Products that use spring force or have gripping force
maintenance contain parts that are under spring tension. This can
cause components to move unexpectedly when being
dismantled, which may result in serious injuries.
•
Carefully dismantle the product.
NOTE
During assembly, the cylinder piston must be aligned precisely.
We therefore recommend having SCHUNK change the seals.
1. Remove all compressed air lines,
}
5.2.2 [
/
26] .
2. Remove product from the system/machine.
3. Remove the cover (12).