Technical Data
12
04.00 | FDB | Assembly and Operating Manual | en | 389072
4 Technical Data
Environmental restrictions
Operation:
Installation position:
Mount on the robot with the lateral mounting hole pattern or
the rear adapter flange. The flange varies from robot to robot.
This optional flange is usually supplied by SCHUNK as a blank,
which the customer can adapt according to their requirements.
Mount on a table or bracket using an adapter plate (the
workpiece is fed in by the robot).
Temperature range:
5° C – 35° C
Storage:
Temperature range:
5° C – 35° C
Storage conditions:
Store the product in packaging in a dry place. If available, store
the product in its delivery packaging
Equipment:
The product requires clean, dry, filtered, oil-free compressed
air. The use of coalescing filters and filter elements with a
nominal value of 5 microns or finer is required. The spindle
must be supplied with 6.2 – 6.5 bar. The radial flexibility
(centered) must be supplied from a regulated source at 1.0 to
1.4 bar.
Technical Specifications
FDB
150
300
340
Motor
Compressed air turbine
Idle speed [RPM]
65,000
30,000
40,000
Power
150 W (0.20 hp)
at 65,000 RPM
300 W (0.40 hp)
at 30,000 RPM
340 W (0.46 hp)
at 40,000 RPM
Weight (without adapter) 1.1 kg
1.2 kg
1.2 kg
Compensation range
(radial)
±6.4 mm max.
radial,
±3.2 mm
recommended
±7.5 mm max., ±3
mm recommended
±7.5 mm max., ±3
mm recommended
Deflection force
(measured at the collet)
0.9 – 5.8 N,
at 1 – 4.14 bar
12.7 – 42 N
at 1.0 – 4.1 bar
12.7 – 42 N
at 1.0 – 4.1 bar
Deburring speed
Depending on the geometry of the grinder and the motor
speed
Spindle air pressure
6.2 bar maximum
6.2 – 6.5 bar [6.9 bar
max]
6.2 – 6.5 bar [6.9 bar
max]
Air consumption (idle)
1.42 l/s (3 CFM)
5.6 l/s (6 CFM)
5.6 l/s (6 CFM)
Air consumption
(blocked)
3.78 l/s (8 CFM)
10.2 l/s (21.5 CFM)
10.2 l/s (21.5 CFM)
Noise pressure level *
78 dB(A) (without
milling cutter)
78 dB(A) (without
milling cutter)
78 dB(A) (without
milling cutter)