•
7
•
NOTE:
The USB power will automatically
turn off if not used for 10 minutes.
8.5 USING THE LED LIGHT
1.
Press the
button:
• once –
for steady light
• twice –
for a flashing light
2.
When finished using the light, press the
button again, to turn off the light.
8.6 USING A MEMORY SAVER
(not included).
The unit can be used with a memory saver
to save the vehicle’s on-board diagnostic
computer settings (radio programs,
diagnostic codes, etc.) while the battery
is disconnected from the vehicle during
repair or maintenance. We recommend the
SECF-12V-OBD or OBD-L memory savers.
9. DISPLAY MESSAGES
Messages during recharge:
CHARGING - xx% (
Green LED lit) –
Plugged into the AC or DC charger and
internal battery is recharging .
FULLY CHARGED
(Green LED pulsing) –
Plugged into the AC outlet and internal
battery is completely charged.
BATTERY TOO HOT TO CHARGE –
Remove charger and allow battery to cool
down before recharging.
BATTERY TOO COLD TO CHARGE –
The temperature of the internal battery is
too low.
CHARGING-USB ON –
The USB function
is in use while the internal battery is
recharging.
CHARGING-12V ON –
The 12V function
is in use while the internal battery is
recharging.
FULLY CHARGED-USB ON –
The
internal battery is fully charged and the
USB is in use.
FULLY CHARGED-12V ON –
The internal
battery is fully charged and the 12V port
is in use.
UNPLUG CHARGER –
Attempting to use
the jump starter while the unit is recharging.
CHARGE ABORTED-SEE MANUAL –
Charging cannot be completed normally.
Messages during use of 12V/USB:
USB ON-BATTERY xxx% –
The USB
port is in use. The % shows the battery’s
charge.
12V ON-BATTERY xxx% –
The 12V port
is in use.
USB/12V OVER LOAD –
The 12V/USB
port is overloaded.
BATTERY LOW-RECHARGE –
While
using the 12V/USB, the battery voltage
has dropped. The 12V/USB power will shut
off after 10 minutes.
Messages during use of jump starter:
xx.xV
–
Clamps are connected to a car
battery, but jump start button was
not pressed.
CONNECT CLAMPS-BATTERY xxx%
–
Unit is turned on, but does not detect
battery clamps.
WARNING-CLAMPS REVERSED
(alarm sounds) – The clamps are
connected backwards to a battery.
BATTERY LOW-RECHARGE
– The jump
start button has been pressed, and the
internal battery is discharged (will beep).
TURN OFF USB/12V
– Attempting to
jump start when 12V/USB function is
activated.
OFF
– The jump start button has been
pressed twice.
BATTERY TOO HOT –
The internal
temperature of the battery is too warm.
Allow battery to cool down before
attempting another jump start.
JUMP START READY-BATTERY COLD
REDUCED PERFORMANCE
– The
temperature of the internal battery is too
low, which reduces cranking performance.
JUMP START READY
– The jump start
button has been pressed, unit is correctly
connected to a car battery, and the unit is
ready for jump start.
10
– Maximum 10-second-down counter
for engine start.
BATTERY COOL DOWN xx SEC
REMAINING
– Shows waiting time needed
before attempting another engine start.
10. MAINTENANCE INSTRUCTIONS
10.1
After use and before performing
maintenance, unplug and disconnect
the unit.
10.2
Use a dry cloth to wipe all battery
corrosion and other dirt or oil from the
battery clamps, cords, and the outer case.
10.3
Do not open the unit, as there are no user-
serviceable parts; any servicing should be
performed by qualified service personnel.
