•
9
•
10. REPLACEMENT PARTS/ACCESSORIES
Battery clamp jaw replacement kit
.................................................................. 2299001580
Male-to-male accessory cable ............................................................................ 94500109
BATTERY CLAMP JAW REPLACEMENT
1.
Make sure the rotary switch on the
front panel is in the OFF (O) position
and the jump starter is not plugged
into a 120V AC wall outlet.
2.
Secure the clamp in the open position
using a vise or equivalent clamping
device.
WARNING:
The clamps are spring loaded,
so use caution when replacing the jaws, to
avoid injury.
3.
Remove the rear screw that attaches
the jump starter cable to the jaw.
4.
Remove the screw holding the copper
jaw to the plastic clamp. Repeat for
the other jaw.
5.
Remove the two jaws and braided
cable.
6.
Reverse the steps to install the
replacement clamps.
