26
8. OPERATION
FIGURE 8.1
Using the vacuum cleaner with solids (dust):
Always use filters when vacuuming solid particles (dust), otherwise you will damage your product.
Attach the hose to the side inlet opening on the dust compartment (Figure 8.1).
After use, clean it. It will extend the life span of your product.
Note
: Check if the accessories are properly attached before using them.
Using with liquids:
Remove the filter when aspiration the liquids (model 1200W).
The aspirated liquid stays in the dust compartment. When the liquid reaches the maximum level, the vacuum
cleaner will stop sucking and you will notice a change in the noise emitted by the product. It happens because of
the sealing float, which prevents the liquid from getting in contact with the motor.
Turn off the equipment immediately and unplug it from the power outlet.
Empty the dust compartment and proceed with cleaning again.
Before putting the vacuum cleaner away after using it with liquids, dry it off. Leaving water inside it will cause
gradual damage.
After aspiration the liquid, let the filter drying completely. Not aspire dust with filter wet (model 2000W).
Never point the hose in the direction of people and animals. This might cause serious
accidents.
ATTENTION
Replacing filters:
A.
Release the side clips and lift the top lid by the handle
;
B.
Remove the filters
;
C.
Fit a new filter in the place
(Figure 8.2 and 8.3);
D.
Place the top lid on the dust compartment again and lock the side clips
.
Summary of Contents for Hidropo 1200W
Page 31: ......
