8
3. Installation of the suspension system.
1º- Select the downrod (2A or 2B) you wish to use according to the desired height of the fan.
2º- If it isn´t already been pre-installed, use the pin and set-screw to insert the hemisphere onto the selected downrod.
3º- Place the canopy and the connector cover onto the tube, in the order indicated in the diagram below.
4º- Loosen the screws and remove the pin from the connector ring (placed in the upper part of the fan body) and insert the downrod
tube, after having previously fed the wires through the tube. Rotate until the holes are aligned and reinsert the pin, secure with the
R-clip, and tighten the ring screws until the tube is firmly fixed in place (tighten the screws on all sides to an equal depth so that the
tube is centred). Cover the connecting ring with the connector cover.
5º- Place the tube down rod with the semi-sphere on the mounting bracket, and rotate the assembly until it engages the four snap-
in slots and is firmly seated.
6º-Next to the ceiling bracket, connect the module to the wires that come out from the top downrod topside. Then connect the
network cable to the INPUT cables of the module. Once all are connected, insert the module into the reserved space on the ceiling-
mount.(with adhesive pads to attenuate possible sounds due to vibration of the module)
adhesive pads
