Schroeder America ARIZONA TEA DISPENSER 925, Installation Instruction, Parts List And Configuration Manual

Page: 2 / 16

2
1. DISPENSER DIMENSIONS AND WEIGHT
A. Single valve dispenser weight is 14.5 lb.
B. Single valve shipping weight is 16 lb.
2. WATER AND SYRUP REQUIREMENTS
Minimum Maximum
Water/Soda 40 PSIG (2.8 kg/cm2) 110 PSIG (7.73 kg/cm2)
Syrup (Sugar) 20 PSIG (2.8 kg/cm2) 70 PSIG (4.92 kg/cm2)
Water/Soda 10 PSIG (2.8 kg/cm2) 70 PSIG (4.92 kg/cm2)
3. INSTILLATION
Water pipe connections and fixtures directly connected to a potable water supply shall be sized,
installed and maintained in accordance with federal, state and local codes.
IMPORTANT
THIS EQUIPMENT TO BE INSTALLED WITH ADEQUATE BACKFLOW PROTECTION.
A. Drain Attachment
1. U sing 1/2 I.D. flexible drain tube, cut tube to desired length.
2. Attach end to adaptor fitting (P.N. 675-0062) (Fig. 3.1)
3. Insert adaptor into u-slot of base
4. Extend drain line beneath unit to drain source
5. Mount base as indicated in next section B. Urn/Base Mounting before continuing
6. When using the built in drain option, first drill out drain using 5/16 or *21/64 preferred
NOTE:
All drip trays have drain “blocked off” as molded/supplied.
a. Insert drill into back of drip tray. Drill through back wall of drip tray, extending hole through
wall into rib, completely exposing cavity of drip tray to drain hole.
b. Clean off any debris with x-acto knife.
c. Place drain on counter & plug into drain adaptor on unit (675-0062).
Drain Tube
Clamp
Fig. 3.1