26
2. INSTALLATION
2.1 Electrical connection
This equipment must be connected to a grounding plant. Two types of electrical
connection can be used:
1.
Using a standard plug to be connected to the power cable and inserted in a mains
socket which must be accessible (so that the plug can be disconnected when servicing
is carried out). Make sure that the plug is accessible also after the complete installation
of the equipment.
2.
By means of a fixed mains connection, fitting a bipolar switch, which ensures
the disconnection, with an opening distance of the contacts allowing a complete
disconnection on the conditions of the overvoltage III category, according to installation
regulations. The ground connection (yellow-green wire) must not be interrupted.
Refer to the rating plate inside the hood for the mains voltage and frequency ratings.
If the power cable is damaged, it must be replaced by the manufacturer or by its service
agent or a qualified person in order to avoid any risk.
2.2 Filtering mode
This hood has been designed to work exclusively in filtering mode.
The aspirated fumes pass through the Plasma filter and are re-introduced into the
kitchen without odors
(Fig. 3).
2.3 Installation
Read the instruction manual before installing and/or using the hood.
In order that the minimum distance between the support surface of the cooking
vessels in a gas hob and the low voltage components present in the hood is at least
65cm. As required by current legislation, the lower part of the hood should be no less
than 60cm away from these supports. If the installation instructions for the gas hob
indicate a greater distance, it must be taken into account.
(Fig. 4).
NOTE : It must not be superimposed on stoves with an upper radiating plate.
Respect all the air discharge regulations. The air must not be discharged in a pipe used
to discharge exhaust fumes produced by gas-fed equipment or fuel-fed equipment
(this does not apply to filtering hoods).
The room must be adequately ventilated when the hoods is used together with other
gas or fuel equipment.
The hood placed above an induction hob can cause condensation, this is a normal
phenomenon and not due to malfunctioning of the product.
For an easy access, it is advisable to move possible furniture under the installation area.
Summary of Contents for SOHD1600B
