SCHOLTES SH09PGWAX, Operating Instructions Manual

Page: 9 / 16

GB
9
! The position of the corresponding gas burner is
shown on every knob.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
z Off
Maximum
Minimum
To light each of the burners, press down the
corresponding knob and turn it anti-clockwise to the
maximum setting.
Since each burner is fitted with a flame supervision
device, the knob should be pressed and held for
approximately 2-3 seconds to allow the automatic
device keeping the flame alight to heat up.
!
When there is no electricity supply, the burners
can be lit with a match after turning the control
knob to the flame position.
To turn on one of the burners, place a lighted match
or lighter near the burner, press the knob all the way
in and turn it anti-clockwise to the "High" setting.
! If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before
trying to relight it.
To switch off the burner, turn the knob clockwise until
it stops (when reaches the “
z ” position).
Double crown wok burner
This burner consists of two concentric burners which
can operate either together or separately.
Use of the double crown wok burner on the
maximum setting gives a very high power which
reduces cooking times with respect to conventional
burners.
Moreover the double crown wok provides a more
uniform distribution of heat on the bottom of the pan,
when using both burners on minimum.
To ensure that the double crown wok is used to its
full potential, never set the inside ring to minimum
and the outside ring to maximum at the same time.
Pots and pans of all sizes can be used. In the case
of the smaller pots and pans we recommend the use
of only the internal burner.
There is a separate control knob for each of the
parts of the double crown wok burner.
The knob marked by the symbol operates the
external burner;
The knob marked by the symbol operates the
internal burner.
To turn on one of the burners press the relevant
knob all the way down and turn it anti-clockwise to
the full setting. To adjust the power of the burner
and turn it off, follow the instructions previously
described.
Practical advice on using the burners
To ensure the burners operate efficiently:
• Use appropriate cookware for each burner (see
table below) so that the flames do not extend
beyond the bottom of the cookware.
• Always use cookware with a flat base.
• This product is supplied with a specifically
designed Wok stand. Placed on the special
Double crown burner, the support will allow the
use of larger wok pans, with non flat base,
providing stability.
• When the contents of the pan reach boiling point,
turn the knob to minimum.
Burner
ø Cookware diameter
(cm)
B. Semi Fast 16 - 22
A. Auxilliary 10 - 14
C. Oval burner 16 - 22
D. Double crown wok
(inner DCDR)
10 -14
D. Double crown wok
(outer DCDR)
26 - 28
!
Make sure the pans do not overlap the edges of
the hob while it is being used
!
This hob is supplied with a pan support adaptor.
This accessory should be used to increase the
stability on the Double crown wok burner when only
the inner part (inner DCDR) is operated and there is
the need to place small pans (under 12 cm
diameter) on it.
To identify the type of burner, refer to the designs in
the section entitled, "Burner and Nozzle
Specifications".
Start-up and use