17
EN
Loading the detergent
A successful wash also depends on the correct
amount of detergent being used, as recommended by
the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
Only use detergent which has been specifically
designed for dishwashers.
DO NOT USE washing up liquid.
Using excessive detergent may result in foam
residue remaining in the machine after the cycle has
ended.
The use of tablets is only recommended for models
which offer the MULTI-FUNCTIONAL TABLETS option.
To achieve the best results from each washing and
drying cycle, powder detergent, rinse aid liquid and salt
should be used.
compartment A
: Washing detergent
compartment B
: Pre-wash detergent
1. Open cover C by pressing
button D.
2. Pour in the detergent after
consulting the
Wash cycle table
:
for powder detergent use
compartments A and B
for tablets: when the
cycle requires 1 tablet, place it
in compartment A
and close the cover; when it
requires 2, place the second tablet at the bottom of the
appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks
.
Washing options*
All-in-one tablets*
When using multi-use tablets, press the all-in-one
tablets button. This option optimises the results of the
wash. The overall duration of the programme increases
by approximately 10 minutes.
This option is not recommended for use with wash
cycles which do not specify the use of multi-use tablets
(
see table of wash cycles
).
A
B
D
C
Start-up and use
Starting the dishwasher
1. Turn the water tap on.
2. Press the ON/OFF button: the indicator light will
illuminate.
3. Open the door and pour in a suitable amount of
detergent (
see below
).
4. Load the racks (
see Loading the racks
) and shut the
door.
5. Select the desired wash cycle depending on the
dishes and how dirty they are (
see table of wash
cycles
), by turning the knob clockwise.
6. Select the wash options
*
(
see below
).
7. After a few minutes the cycle start and the WASH
CYCLE PHASE indicator lights display the status of the
cycle:
Pre-wash, Wash, Rinse, Drying.
8. At the end of the cycle two short beeps will sound and
the DRYING indicator light will flash.
9. Turn the knob anti-clokwise to RESET in order to reset
all the settings.
10.Switch off the appliance by pressing the ON/OFF
button, shut off the water tap and unplug the
appliance from the electricity socket.
11.Open the door and wait for a few minutes before
removing the crockery, in order to avoid burns.
Unload the racks, beginning with the lower level.
Modifying the duration of a wash cycle already
in progress
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that
it has only just begun: turn the knob anti-clockwise until
it reaches the RESET position. After a few seconds one
long beep and three short beeps, the WASH CYCLE
PHASE indicator light will switch off: select the new
cycle.
Adding extra crockery
Press the ON/OFF button and open the door, taking care
to avoid the escaping steam, and place the crockery
inside the dishwasher. Press the ON/OFF button again:
the cycle starts from the point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there is
a power cut, the cycle stops. It starts again from the point
at which it was interrupted once the door has been shut
or the electricity supply is restored.
*
Only available in selected models.
