Features
:
• Tube Microphone Amplifier with Power Supply / Filter / Attenuator / Line Driver
• Fits to any SCHOEPS Colette Series capsule and all the Active Accessories
such as CUT1, KC, RC, GVC and BLM03C
• Same dimensions as SCHOEPS CMC microphone amplifier
• Frequency range: 10 Hz - 30.000 Hz (measured with SCHOEPS omni MK2S)
• Maximum sound pressure level (measured with omni MK2S into 10 k load):
142 dB SPL without attenuation
• FILTER (switchable): 150 Hz (6 dB/oct) ("P 48": 30 Hz)
• 5 - step HARMONICS switch emphasizes the typical tube sound
• Switchable line driver "P 48" allows cable lenghts up to 200 m connected to
a phantom-powered microphone input
• Output switchable to unbalanced operation
• All signal switches with gold-plated contacts
• LEDs "ON", "P 48" (line driver), "UNBAL." (unbalanced operation)
• AC mains 220 V or 110 V, 3 VA
• Output M 222: XLR 5 (gold-plated), transformerless, balanced
• Input NT 222 AC: XLR 5 (gold-plated), balanced, transformerless
• Output NT 222 AC: XLR 3 (gold-plated), balanced, transformerless, output
impedance 500 allows cables up to 40 m ("P 48": 50 up to 200 m cable),
possible unbalanced operation without loss of level, connectable to
any
microphone input (with or without powering, balanced or unbalanced, middle or
high impedanced)
• Solid construction (metal case)
• Complete set with wooden case, cables, popscreen and clamp
Installation
:
Please asure that your mains voltage corresponds to the value marked at the rear
panel of your NT 222 AC.
WARNING
: Never open the case with a mains cord connected to the mains.
Severe damage may occur by electrical shock. If there are any
doubts concerning the proper function of the unit always pull out
the mains plug first.
Connect your new Tube Microphone Amplifier M 222 via the included Microphone
Cable KS 5 U (5 m) to the NT 222 AC. Screw the SCHOEPS Colette capsule of
your choice or the wanted Active Accessory onto your M 222. Keep in mind that
when using any Active Accessory your signal path does not start with the tube but
with the FET of your KC, RC, CUT1 or BLM03C.
For close speech with cardioids or outdoor use in light wind with omnidirectional
capsules put the included B5 on your microphone. For stronger wind, we
recommend the SCHOEPS hollow foam windscreens B5D and W5D. The clamp
SG 20 fits to any 3/8", 1/2" or 5/8" thread.
Connect the output of the NT 222 AC to the microphone input of your equipment.
Notes:
For troublefree operation we always recommend balanced operation, making
the cables as short as possible and avoiding proximity to mains cables. If these
must be crossed, then please do so at right angles. Indoor use only. Always
keep dry. Never connect any other than the SCHOEPS M222 microphone to
this power supply as this may cause severe damage to the other microphone.
Subject to change without notice.
