II/ 12
FSP
GB
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
***For troubleshooting: read chapter: "Commissioning"!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
E Material accumula-
tion concentrated in
the middle
Too much material application
X
Use smaller nozzle set Reduce
paint quantity (item 03):
Decrease material pressure
(item 18):
Working pressure (flow pres-
sure) too low
X
Increase working pressure (flow
pressure) Observe maximum
working pressure
*
Viscosity is too high
X
Decrease viscosity or increase
material pressure (item 18)
F Spray pattern
moved to one side
Dirty or deformed holes on the
flanges of the air cap
X
Clean
****
or replace complete
nozzle set (see Figure 3a-c)
***
Problem
Cause
Remedy
Summary of Contents for FSP-FP-HTE2-1
