Operating and Menu Concept
EN-US · 30.30.01.02084 · 02 · 12/20
17 / 72
5 Operating and Menu Concept
The parameters can also be set using three buttons. The current system status and the settings are shown
on a display.
The unit is operated via three buttons on the foil keypad. Settings are configured using software menus.
The operating structure is divided into settings in the main menu and configuration menu. Setting the
ejector in the main menu is sufficient for standard applications. The advanced configuration menu is
available for applications with special requirements.
If settings are changed, undefined states of the system may occur for a short time (for approx. 50 ms).
5.1 Enabling the Menu
Menus can be protected against unauthorized access by defining a PIN [
Pin
] in the configuration menu.
When the lock is active, [
Loc
] flashes on the display or the PIN is requested.
The menus are accessed as follows:
1. Press the
button
ð
The display changes to input
2. Use the
or
buttons to enter the first digit of the PIN
3. Confirm using the
button
4. Enter the remaining digits in the same way.
5. To enable the device using the menu, press the
button
The lock is activated again automatically after you leave the selected menu or close the function.
The PIN [
000
] must be set for permanent deactivation of the lock.
Tips and Tricks for Parameter Setting
•
By pressing the
or
button for approx. 3 seconds, the value to be changed is
scrolled through quickly
•
If you exit the changed value by briefly pressing
, the value will not be applied.
5.2 Individual Functions
Displaying the vacuum level:
Outside of the menu, the ejector is in display mode and the current vacuum level is displayed.
In display mode, a specific function is assigned to each key.
Displaying the supply voltage:
4
Press the
button
ð
The supply voltage that is currently applied to the ejector is displayed in volts.
After 3 seconds, the screen returns to the vacuum display.
The displayed voltage is a guideline value and is used for comparative measurements.
Displaying the operating mode:
4
Press the
button
ð
The current operating mode is displayed.
It is either standard I/O (SIO) mode [
510
] or IO-Link mode [
10L
].
