Quick Start Guide | Uni-M Panduit Ferrule Applicator in UniCrimp 200
Edition 1.4P (09-2019)
www.schleuniger-na.com
2
3
Programming split cycle and press timing
Step
Change
Screen
Value
Starting from the “Counters: / Batch:” screen, press the
following buttons in the sequence described.
Counters: / Batch:
Enter
Screen changes to
Menu: Counters
+
Screen changes to
Menu: Functions
Enter
Screen changes to
Crimp Speed
100%
+
Screen changes to
Crimp Force
Off
+
Screen changes to
Pneum Valve
Off
+
Screen changes to
Split Cycle
Off
Enter
Enter highlights “Off”
Split Cycle
Off
+
+ changes “Off” to “On”
Split Cycle
On
Enter
Enter confirms change and highlights
the value
Split Cycle
80
º
+
(press and hold to get a value of 160º)
Increments value
Split Cycle
160
º
Enter
Enter confirms change
Split Cycle
+
(if necessary, use the +/- keys to change value)
Screen changes to
Split Cycle Speed
5%
[Esc]
Screen changes to
Menu: Functions
[Esc]
Screen changes to
Counters: / Batch:
Verify/set crimp height dials
1.
Ensure the top crimp height dial (10) is set properly according to the Index value on the ID plate.
2.
Each major increment represents an index value of the number divided by 10
a.
Examples:
Dial setting on 8 refers to an index setting of 0.8.
b.
Example:
Dial setting on 19 refers to an index setting of 1.9.
c.
Photo shown of the dial refers to an index setting of approximately 1.94.
3.
Each increment (or click) of the top dial changes the crimp height by in a 0.01mm. This is also used for the
index value.
a.
To achieve an index setting of 0.85, start at “8” on the top crimp dial (9) and turn the dial clockwise 5 clicks (0.80 +
5*0.01 = 0.85)
b.
To achieve an index setting of 1.23, start at “12” on the top crimp dial (9) and turn the dial clockwise 3 clicks (1.20 + 3*0.01 = 1.23)
Load the ferrules
11.
Remove air pressure to the applicator.
12.
Bring the press ram to the top center position using the jog buttons.
13.
Lift the safety shield.
14.
Remove the funnel unit (11).
15.
Lift the ferrule brake lever (12).
16.
Select the proper ferrule according to the applicator ID plate.
17.
Install ferrule strip until the first ferrule reaches the end of the track.
18.
Lower the ferrule brake lever (12).
19.
Apply air pressure to the applicator and lower the safety shield.
20.
Lower the tooling with the jog button. If the ferrule strip is advanced properly, the tooling will capture the first ferrule properly.
13
12
11
