Form 51005 Rev. D
12-02-2002
2
CM5100 COMPUTER MANAGED CYLINDRICAL LOCK
INSTALLATION MANUAL
1. PREP DOOR AND FRAME:
A. Determine door hand and correct backset.
B. Mark the horizontal and vertical centerlines for the lockset, latch and strike.
C. Place template on inside of door (opposite the side that the keypad/reader will be on). Line up the correct reference lines
on the template with the edge of the door. The centerline on the door should line up with the vertical centerline of the tem-
plate.
D. Drill holes as described by template.
BEFORE YOU BEGIN:
Standard units are shipped from the factory to fit 1-3/4” doors. Verify that the door thickness. If the door is not 1-3/4” thick,
verify that the door thickness option was ordered or consult factory.
DOOR EDGE (LATCH)
FRAME (STRIKE)
DOOR FACE (LAY OUT ON INSIDE)
