9
TREE FARM
MOWER
SERVICE
Changing Main Drive Belts
• 1. Remove the top shield.
• 2. Release the idler springs and remove upper drive belt.
• 3. Remove the 4 bolts from the right spindle support. Tilt the support and remove the lower drive belt.
NOTE: This support will move far enough to allow the lower belt to be removed and installed
without loosening any spindle bearings.
• 4. Install the new lower belt.
• 5. Re-install the right spindle support, and install the new upper belt.
• 6. Hook the idler springs to the idler arms, and replace the top shield.
ALIGNMENT OF U-JOINTS
Whenever the drive shaft u-joints are disconnected it is necessary to align the two u-joints when
reconnecting the square shaft. It is possible to assemble the joints 90 degrees from correct
alignment. Incorrect alignment will cause excessive vibration and shorten joint life.
See diagram below.
Summary of Contents for 73-70805
