Please observe the following instructions
for the long service life of your device.
20
·
Store in a dry place and do not
wash with water.
·
Clean the transducer with a
damp cloth.
·
Place the device into the char-
ging dock after switching-off
and make sure the red LED
light glows.
·
The red LED light turns green
when the charging process
has been completed. In the
case of charging errors, the
red LED will flash.
·
If the battery is completely
empty charge it for at least 3
hours before using the device
again.
·
When completely charged the
power will last for approxima-
tely 4 hours.
·
Keep the STEP button pressed
for about 3 seconds to indica-
te the charging status of the
battery. If the 6 LED program-
me lights glow the device is
fully charged. If only 2 LED
lights glow, the remaining
battery power is 30 minutes.
A signal tone indicates the
battery needs to be recharged.
·
The device will automatically
switch-off after 2 minutes if
not in use.
·
The preset application time
of each step is 4 minutes.
A signal tone sounds after
4 minutes and the device
switches to standby mode.
The device will switch-off
completely if not reactivated
within 2 minutes.
·
The nominal input voltage
is 100-240 V AC, meaning
that you use the device while
travelling everywhere around
the world.
·
Remove the power plug from
the charging station as soon
as the device has been char-
ged completely.
·
Always keep electrical con-
tacts clean, free of dust and
dry.
Maintenance, recharging, environmental
protection
21
For recycling reasons, the
device should not be disposed
of with normal household
waste at the end of its service
life. You can dispose the device
by returning to Schick Medical
GmbH or corresponding collec-
tion points.
© All rights reserved by the
Schick Medical GmbH.
All content is subject to
copyright.