Scheppach 5901208901, Translation Of Original Instruction Manual

Page: 22 / 256

22 GB
1. Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
•
Improper handling,
•
Non-compliance of the operating instructions,
•
Repairs by third parties, not by authorized service
technicians,
•
Installation and replacement of non-original spare
parts,
•
Application other than specified,
•
A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
WE RECOMMEND:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture.
Read the instruction manual each time before op-
erating the machine and carefully follow its informa-
tion. The machine can only be operated by persons
who were instructed concerning the operation of the
machine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
In addition to the safety notices contained in this
operating manual and the particular instructions for
your country, the generally recognised technical reg-
ulations for the operation of identical devices must
be complied with.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
2. Layout (Fig. 1-19)
1.
Handle
2.
ON/OFF switch
3.
Release lever
4.
Saw shaft lock
5.
Machine head
6.
Movable blade guard
7.
Saw blade
8.
Clamping device
9.
Workpiece support
10.
Locking screw for workpiece support
11.
Table insert
12.
Indexed position lever
13.
Locking lever
14.
Pointer
15.
Scale
16.
Turntable
17.
Fixed saw table
18.
Stop rail
19.
Scale
20.
Pointer
21.
Sawdust bag
22.
Locking screw
23.
Locking screw for drag guide
24.
Fastening bolt
25.
Drag guide
26.
Screw for cutting depth limiter
27.
Stop for cutting depth limiter
28.
Movable stop rail
29.
Set screw for moveable stop rail
30.
Adjustment screw (90°)
31.
Adjustment screw (45°)
32.
Flange screw
33.
Outer flange
34.
Laser
35.
ON/OFF switch for laser
36.
Battery compartment
37.
Battery compartment cover
38.
Screw
39.
Inner flange
40.
Guide bar
41.
Spring
42.
Switch for switching speeds
a) 90° stop angle (not supplied)
b) 45° stop angle (not supplied)
c) Allen key, 6 mm
3. Scope of delivery
•
Open the packaging and remove the device care-
fully.
•
Remove the packaging material as well as the
packaging and transport bracing (if available).