30 english
Pre-cutter,
Fig. V
IMPORTANT: Only insert sharpened, flawless, not deformed
original Scheppach saw blades.
Replace the table insert when a sawing gap is made.
BE CAREFUL! Disconnect power plug when changing blades
1 Retain arbour
2 Flat headed screw M8
• Slide format sliding table forwards, open the protection
cover with both hands.
• Insert the retain arbour (1) through the borehole of the right
table half into the saw axle. Block the saw axle with the
retain arbour to loosen or tighten the flat headed screw (2).
• Pay attention to the saw blade direction.
Fig. W, Y
• The overhang of the precutter saw blades on the table
surface is, depending on the cutting width of the machine’s
saw blades 1.0 – 2 mm.
• The height adjustment is carried out by means of the screw
(2) Fig. V.
• 1 turning is 1.5 mm (picture Y)
• The width of the precutter saw blades is adjusted with the
spacer (A) (1 x 0.1 mm, 2 x 0.2 mm, 1 x 0.3 mm) see Fig.
W
• The precutter should be as wide as the machine’s saw
blades.
2,8 mm – 3,6 mm are possible
• The flight of the precutter saw blades to the machine’s saw
blades are adjusted by screw (3) picture V
• 1 turning is 0.1 mm (picture Y)
Carry out trial cut.
Lower the precutter with the screw (2) under the table level
when not in use.
Attention! Close protective cover again.
Abb. V
Abb. W
Abb. Y
1
2
3
4
SW 5
A
0,1 mm/
1,5 mm/
3
4
