5
– FUNCTIONING AND USE
COD.60M12/24.A.2018
EN
THE PRESENT MANUAL BELONGS TO -
Schenker Italia
- ALL RIGHTS RESERVED
37
13.2.1 Normal operating procedure with automatic washing on (advisable procedure)
1. Switch on both pumps by rotating clockwise
the Pump 1 and Pump2 selector.
(By activating only one pump the system will
work at half power and the production will
drop to 30 lt/h at 100 Watt/h consumption).
2. Switch on the Automatic Washing selector.
3. Push the button START. The green led will
switch on and the production starts.
4. Push the STOP button when finishing the
running time needed.
The automatic washing will start and the blue
led will switch on for the whole washing time
(around 1 minute).
The system will switch off automatically after
when the automatic washing is complete.
The fresh water consumed for the automatic washing
is about 25 lt.
13.2.2 Normal operating procedure with automatic washing off (not advisable procedure)
CAUTION
It is not advisable to use the watermaker without automatic washing on because the deposit
of salt within the system for long period could damage the pump and reverse osmosis
membranes.
1. Switch on the pump by rotating clockwise the
Pump 1 selector.
2. Switch off the Automatic Washing selector.
3. Push the button START. The green led will
switch on and the production starts.
4. Push the STOP button when finishing the
running time needed.
Do not switch off the system by acting on the
pump1 or pump2 selector in order to avoid
hydraulic faults of the unit.
NOTE
It could occur
that the system doesn’t stop immediately when stop button is pushed, but it rather
stops after a while. This behaviour is absolutely normal because the electronic central unit waits for
the hydraulic clock signal before switching off in order to avoid hydraulic system block.
CAUTION
If during normal running operation the computer detects an irregular condition (not constant
cycling, low pressure, etc…) the system switches off automatically after 20 sec, and STOP led
will start flashing. To make watermaker run again, it is first necessary to press STOP button (in order
give a feedback to the system that the issue has been recognized). Before pressing STAR to run the
watermaker again, be sure to individuate the cause of the anomaly and solve the issue.
