DT 220 B control and switch panel instruction manual
24
Issued: 30.06.2006
830.588 BA / EN
5.6.2 Faults
The majority of power supply system faults are caused by blown fuses (see
the instruction manual for the associated Electrobloc with regard to informa-
tion about voltage distribution and fusing).
Please contact our customer service address if you cannot eliminate the
fault using the following table.
If this is not possible, e.g. if you are abroad, you can have the control and
switch panel panel repaired at a specialist workshop. In this case you must
ensure that the warranty is not invalidated by incorrect repairs being carried
out and Schaudt GmbH will not accept any liability for damage resulting from
such repairs.
Fault
Possible causes
Remedy
12 V power supply does
not work (or power is not
b i
li d t
t i
12 V main switch is
switched off.
12 V main switch must be
switched on.
being supplied to certain
sections).
Fuse blown.
See EBL ... Electrobloc
instruction manual.
System cannot be
switched on.
Leisure battery has not
been recharged (voltage
is less than 11.0 V);
battery monitor has
switched the system off.
Recharge the leisure
battery.
Fuse blown.
See EBL ... Electrobloc
instruction manual.
Leisure battery is flat.
Leisure battery has been
discharged
Recharge the leisure
battery immediately.
The leisure battery will be
irreparably damaged if it
remains totally discharged
for a lengthy period.
The battery can be
discharged by inactive
consumers such as the
frost protection valve in
the combined heating
system
Fully recharge the leisure
battery before you shut
down the motorhome for a
lengthy period
The “Check mains”
symbol is not displayed
th
h it i
No power coming from the
mains supply.
Check the mains supply
(e.g. camping site).
even though it is
connected up to the
230 V power supply.
The power cut-out to the
Electrobloc has tripped or
is switched off.
Reset the power cut-out.
5.6.3 Check the software version (SW vers.)
The software version must be known for service purposes or for answering
the manufacturer’s questions. It can be determined as follows:
³
Press the “Main menu” button.
F
The display will illuminate.
F
The time and other symbols (if required) will be displayed.
³
Press the “Set up” menu button and keep it held down for at least 3 s.
F
The display will change over to main menu set up mode.
³
Repeatedly press the “Set up” button until a letter appears in the first digit.
F
The software version will now be displayed, e.g. “U1.11”.
Flat vehicle fuses
