Schaub Lorenz 32LT655C, Instruction Manual

Page: 68 / 85

English - 67 -
Cable Installation
Select Cable Installation line in the Installation menu
and use OK button to view the menu contents:
Automatic Channel Scan
Automatic channel scan is started by pressing
OK button while Automatic channel scan item is
highlighted. The following message appears on the
screen:
Highlight Yes or No by using “ ” or “ ” buttons
and press
OK button to con  rm. If Yes is selected,
automatic search starts. Selecting No cancels
automatic search.
You can select frequency ranges from this screen. For
highlighting the lines you see, use “ ” or “ ” button.
You can enter the frequency range manually by using
the numeric buttons on the remote control. Set Start
and Stop Frequency as desired by using numeric
buttons on the remote control. After this operation,
you can set Search Step as 8000 KHz or 1000 KHz.
If you select 1000 KHz, the Tv will perform search
process in a detailed way. Searching duration will
thus increase accordingly. When
 nished, press OK
button to start automatic search.
When
 nished, press OK button to start automatic
search. Automatic searching screen will be displayed
during the process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.
After search is completed for digital channels, a
message asking whether to search for analogue
channels appears on the screen: Operation of
analogue channel installation is explained in
“Automatic Channel Scan” section above.
Frequency Search
Enter the desired frequency, Modulation and symbol
rate numbers. Modulation can be set as Auto, 16QAM,
32QAM, 64QAM, 128QAM and 256QAM.
When
 nished, press OK button, and the TV will start
frequency search.
Network Search
When you select Network Search line and press OK
button, the following menu screen will be displayed
on the screen:
Enter Start and Stop frequency ranges that you
want to search within. After this operation, you
can set
Search Step as 8000 KHz or 1000 KHz.
If you select 1000 KHz, the Tv will perform search
process in a detailed way.Searching duration will
thus increase accordingly. When
 nished press OK
button to continue. The process will then start. During
the
Network Search , if channels that have network
search info are found, the TV will automatically show
the frequencies of those channels and network search
process will end by locating those channels.
After search is completed, a message asking whether
to search for analogue channels appears on the
screen: Operation of analogue channel installation
is explained in “Automatic Channel Scan” section
above.
Clear Service List (*)
(*) This setting is visible only when the Country option
is set to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press “
” or “ ” button to select Clear Service List and then
press
OK . The following OSD will be displayed on
the screen:
Press OK to cancel. Select Yes by pressing “ ” or “ ”
button and press OK to delete all of the channels.
First Time Installation
The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight “
First Time
Installation ” menu item and press OK button, then
you will be asked whether or not to delete the settings.
Selecting “
Yes ” by pressing OK button will delete the
existing channel table.