English
- 43 -
Installing the Batteries to the Remote
1.
Lift the cover on the back of the remote upward
gently.
2.
Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3.
Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT:
The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
SPDIF
VGA
13V dc /18V dc
3
00mAMax.
12V
Aerial or Cable
Satellite
DiSEqC
Switch
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50
Hz. Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the “ ” button,
P+ / P-
or a numeric button on
the remote control.
Press the control switch located on the left side of
the TV. The TV will then switch on.
To Switch the TV Off
Press the “ ” button on the remote control or press
and hold the control switch on the TV, so the TV will
switch to standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED can
also blink when you switch on the TV from standby mode.
First Time Installation
When turned on for the first time, the “language
selection” menu appears. The message “
Welcome
please select your language!
” is displayed in all
language options listed alphabetically.
Press the “
” or “
” button to highlight the
required language, press OK button to select.
“First Time Installation” appears. Use “ ” or “
” button to set the required country, and press
“
” button to select Search Type. Use “ ” or
“ ” to set the desired search type. Available
search types are Digital and analog, digital only
and analog only. When set, press “
” to select
Teletext Language. Use “ ” or “ ” button to set the
“Teletext Language” and select “Scan Encrypted”
using “
” or “
” button. You can set Scan
Encrypted as Yes if you want to scan coded stations
Deafult PIN code can change depending on the
selected country.
If you are asked to enter a PIN code for viewing a
menu option, use one of the following codes: 4725,
0000 or 1234.
Press
OK
button on the remote control to continue and
the following message will be displayed on the screen.
You can activate Store mode (optional) option by
using “ ” or “ ” button. If Store Mode (optional)
is selected, Store mode option will be available in
