•
Keep wireless push buttons out of reach of children.
•
Wireless Push Buttons may only be operated by persons who are familiar with the system and have been
instructed in their function.
•
Use the wireless push button control only when you are in sight of the door / gate.
•
Coding in wireless push buttons must always be carried out within the vicinity of the door operator. Use only
original parts.
•
Protect wireless push buttons from rain, snow, sunlight or dust, otherwise the function of the transmitter may
be impaired
•
To replace the battery, remove the top of the push button by hand.
Programming Video
Please visit www.schartec.de/en
Simplified EU Declaration of Conformity (CE)
Schartec hereby declares that the remote control YET2166 complies with Directive 2014/53/EU. The full text of the EU Declaration of
Conformity is available at the following Internet address: www.schartec.de/en
Information about battery regulation
As a dealer for the distribution of electronic, battery-operated devices, we are obliged by law to inform our customers about the following:
Electrical and electronic devices, as well as batteries, must not be disposed of as household or residual waste, but must be delivered in the
appropriate acceptance and collection points will.
The complete version of the battery law can be found here:
http://www.gesetze-im-internet.de/bundesrecht/battg/gesamt.pdf
SCHARTEC
a trademark of
bau-shop-24 GmbH
Fritz-Müller-Strasse 11
9
73730 Esslingen
Germany
WEEE Reg. Nr.: DE90317979
BattG Reg. Nr.: 21008776
Schartec
wireless push button UPB-1
/ UPB-2
Frequen
cy
:
433,92
MHz
RC
dBm:
1
0
Power Consumption:
≤ 12 mA
Channels
:
1/ 2
Batter
y
:
12V/27A
Working temperature
:
-
2
0°C
to
+
6
0°C
Article number
:
ST
3010
3
5/ ST301036
Model
num
b
er:
YET2166-1/ YET2166-2
Only use in dry rooms
Programming:
Mounting
/ Batter
y Change
1. Gently pull the button off by hand at the upper end.
Then unhook it at the lower end.
2. Fasten the wireless internal push button with two screws at the
desired location on the wall.
ATTENTION! Do not over-tighten the screws as this could break the
lower shell.
IMPORTANT for UPB-2! To teach in the second channel (button 2), proceed in the same way as for channel one.
1.
Press the Code button on the display of the Schartec Move garage door opener. A small dot (.)
will appear in the corner.
2.
Now press the button on the remote you want to use, wait 2 seconds, then press and hold the
same button on the remote again for 2 seconds.
The dot (.) on the display will flash to confirm
the code, then go out.
WARNING!
When teaching in a remote, the operator may be accidentally triggered initiating door movement!