Scharfen ATM-3, Operating Instructions Manual, Page: 12 / 15

Page 12
1. 2.
4.4. Reassembling the parts
Reassemble the parts in reverse order. (4.3. -> 4.1).
Attention! Risk of getting hurt!

Reassemble the parts with concentration

Do not let distract yourself from your work

Place the splice bar of the blade guard onto the plastic bolt.

Turn the blade guard to the blade and see to it that the flange of the
blade guard is positioned in the centre of the blade.

Tighten the blade guard by turning the star knob clockwise by hand.

Turn the carriage back. Tighten the star knob of the carriage.

Mount the end piece holders

Screw tight the fixing screws of the end piece holders
Check again the complete machine.
Only after having checked the machine plug it in for operation.
5. Sharpening the blade
In case the cutting result should no longer be satisfactory or the food products are getting "beards", the
blade has to be sharpened.
Pay attention to the fact that the blade has to be exchanged if the gap between blade
edge and the fixed protecting ring is more than 5 mm.
According to security regulations further sharpening of the blade it is not allowed when
the gap is more than 5 mm.
The supplied sharpening device is loosening its effect. A further sharpening is forbidden.
In case it is necessary to exchange the blade, see point 6.