Schaeffler Technologies
BA 1
15
Utilisation
After cleaning the BEARING-MATE and outer ring,
use the BEARING-MATE as follows:
■
Place the steel strips centrally on the outer ring,
see label
. The bearing can be lying horizontally or
mounted vertically on a shaft.
■
Rotate the ends of the handles uniformly in
a clockwise direction by hand until the steel strips
are firmly in contact with the bearing and are pulled
in to the same extent. Observe the distances
between the labels and the ends of the handles.
■
Tighten the screw heads on the ends of the handles,
observing the correct tightening torque,
see label
.
■
Use a torque wrench to check whether the final
tightening torque is between 14 Nm and 20 Nm.
1
00
01
6B
78
2
00
016
B7
9
