5
Set-Up / Operation (continued)
To prepare for operation:
1. Remove all items from cartons, remove packing
material and place on a level surface. The fan is
mounted on the bracket and the pump assembly is
contained in the lid, so please remove carefully.
2. Place
empty
cooler/tank in approximate location to be
misted. Carrying a full cooler/tank will be difficult as
it will weigh approximately 80 pounds.and is likely to
spill out if tank is tilted back. This can also make the
unit unstable and hazardous to move.
3. Fill cooler/tank with water (and ice, if desired).
DO NOT FILL ABOVE HANDLE RECESS!
4. Place the fan/pump enclosure on the cooler/tank. Be
sure the intake line and filter are in the bottom of
the cooler/tank.
5. Twist the fan/pump enclosure to engage slots in tank.
* Model PVM18LC does not include a tank. Since the
pump enclosure is specifically made to fit a 10 gallon Igloo
cooler, it must be used only with this type of cooler,
supplied by the user.
DO NOT USE THE PVM18LC
WITH ANY OTHER WATER RESERVOIR!
WARNING
TIP HAZARD
• Serious injury is possible.
• Support weight of fan with free hand when moving
tank with wheels.
• Do not fill tank before moving.
• Never operate pump without water supply.
• If leaks are observed, turn pump off and tighten fittings by hand.
• Excessively hard water (high solids) can plug nozzles.
• A plugged filter caused by poor water quality can restrict flow to pump and cause permanent damage.
• Never allow "fog" from the nozzles to come in contact with surfaces. This can cause condensation and water will form
on those surfaces; redirect the fan to prevent this circumstance.
CAUTION
Intake line
(filter lays in
bottom of tank)
