– 2 –
SINGLE-END WINDER
PARTS
1X
main assembly: clamp, base, and
upright with drive axle (metal)
1X
drive wheel
3X
3/8" washers
1X
3/8" e-clip
1X
drive belt
1X
drive shaft (metal)
1X
5/64" hex wrench
HAND BOBBIN WINDER
A
ssembly
I
nstructIons
DOUBLE-END WINDER
PARTS
1X
main assembly: clamp, base,
and upright with drive center tip
(metal for regular and lace)
1X
tail spindle with live center tip
(metal for regular, plastic for lace)
2X
5/16" x 15" metal rods
1X
drive wheel
3X
3/8" washers
1X
3/8" e-clip
1X
drive belt
1X
5/64" hex wrench
TOOLS
hammer
scrap block of wood
FIGURE 1: INSTALL TAIL SPINDLE (DOUBLE-END WINDER ONLY)
INSTALL THE TAIL SPINDLE
(DOUBLE-END WINDERS ONLY)
1.
Place the main assembly on a corner
of a sturdy table, with the drive wheel axle
pointing toward the floor. Using a hammer
and a scrap piece of wood, tap one end of
each 5/16" metal rod into the holes on the
bobbin winder upright (Figure 1). The
rods will measure about 13-1/2" when
they are in all the way.
2.
Attach the tail spindle: press the spring
clamp down and slide the spindle onto the
metal rods with the winding tips facing
each other (Figure 1).
3.
Press the spring clamp and move the
tail spindle along the metal rods to fit your
bobbins, spools, or pirns. The bobbin
winder wheel will turn easily when there
is as little tension as possible on the tail
spindle.
main assembly
upright
5/16" metal rods
drive wheel axle
spring clamp
main assembly base
drive belt
pulley
clamp
live center
axle & tip
drive center tip
tail spindle
