– 2 –
PARTS
1 - Base assembly
1 - Castle assembly
1 - Beater assembly
1 - Reed
2 - Castle braces
2 - Lease sticks
3 - Apron bars
Heddle bar hooks (for 25" looms only)
8 for 4-Shaft (4S) or 16 for 8-Shaft (8S)
Heddle bars: 8 for 4-Shaft or 16 for 8-Shaft
Heddles:
4-Shaft: 15" & 20" – 300; 25"
–
400
8-Shaft: 15"
–
300; 20"
–
400; 25"
–
500
4 - #8 x 1½" Trusshead screws (for 8S
only)
1.
Unpack the table loom and remove
all of the packing material and tape.
Locate the small plastic bag which
contains the hardware and the apron
cords for your loom (see parts list).
2.
On 8-shaft looms only, the cross
brace is only partially secured for
shipping purposes. Remove the
screws (A) on each side and discard.
Raise the cross brace up and screw
into both A & B with the four
1½" trusshead screws.
3.
Loosely secure the castle
braces to the rear legs with
3" trusshead machine screws
and barrel nuts. Place the
castle upright between the
sides of the loom frame
and secure it, threading the
1-1/8" trusshead screws
through each loom side into
the inserts on the inside of
the castle side (2 per side on
the 4S, 4 on the 8S). Secure
the castle brace to the castle
side in the same manner (D)
(1 screw per side on the 4S,
Shaft Lever
Shaft Lever Cord
Castle Side
Rear Leg
Castle Brace
D
Loom Side
A&B
Rubber Pad
Cross Brace
FIGURE 1: ASSEMBLED 4-SHAFT LOOM
4 - Rubber bumpers
2 - Barrel nuts
¼ x 1-1/8" Trusshead machine screws (6
for 4S or 12 for 8S)
2 - ¼ x 3" Trusshead machine screws
Apron cords: 15"
–
6; 20"
–
8; 25"
–
10
