– 2 –
– 3 –
■
Insert the shaft of the quick release
lever into the left side of the wheel,
through the front maiden and on through
the right wheel side. Place the washer and
knob onto the quick release lever shaft,
compressing the spring on the lever side
until there is about an 1/8" or less of space
between the lever and the wheel side.
Close the quick release lever. The knob
should be just tight enough to allow firm
pressure when closing the lever.
If the lever closes loosely, open the lever,
tighten the knob a bit, and try closing the
lever again. If the lever requires a lot of
pressure to close, loosen the knob a bit.
Install the bulky flyer
■
Loosen the front maiden so that it can
be tipped toward you as you sit in front of
the wheel.
■
Place the Scotch tension string on the
bobbin and the drive band into the whorl
groove.
■
Insert the end of the flyer shaft into the
rear maiden bearing.
■
Insert the orifice into the front maiden.
Push the front maiden against the stops,
make sure it is vertical, and secure with
the quick release lever.
adjustIng the front maIden
Look at the flyer from above to where the
orifice enters the front bearing. Push the
flyer shaft toward the rear. There should
remove the
standard front maIden
■
Remove the flyer, bobbin and whorl.
■
Open the quick release lever and
unscrew the knob. Remove the knob and
washer, then pull out the quick release
lever shaft.
■
Remove the front maiden and store.
Install the
bulky front maIden
■
Place the bulky front maiden between
the wheel sides with the logo facing the
front of the wheel.
Contents
■
Bulky front maiden & bearing
■
Bulky flyer
■
Bulky bobbin
quick
release
lever
front
maiden
bulky bobbin, Flyer, and Front maiden
adjustable
flyer hook
stationary
flyer hook
orifice
bearing
flyer shaft
shoulder
