background image

BABY WOLF LOOM

TM

 

A

ssembly

 I

nstructIons

3X  extra 8/32" hex nuts for shafts

3X  extra rubber O-rings for shafts

10X  29" apron cords (or 2X 252" apron 

cords for cherry looms) 

Maintenance and Warranty Manual

4-shaft looms:

  400X heddles

 

24X  tie-up cords

8-shaft and 4 Now-4 Later looms:

  800X heddles

 

80X  tie-up cords

 

10X  black treadle aid cords

PARTS 

Wrapped onto warp beam:

3X   apron bars

2X  lease sticks (with holes)

1X  1/4" treadle aid dowel (8-shaft and 4 

Now-4 Later looms only)

2X  27" apron cord dowels (cherry 

looms only)

Accessory pack:

1X  brass reed hook

1X  warp beam crank handle

1X  3/8" cap nut

1X  3/8" washer

Find out more at 

schachtspindle.com

Schacht Spindle Company 6101 Ben Place Boulder, CO 80301

p. 303.442.3212 f. 303.447.9273

© 2019 Schacht Spindle Company, Inc.

11.19

UNFOLDING THE LOOM

1. 

Remove all plastic wrap from the loom. 

Remove both shipping braces by slightly 

loosening the back beam knobs and 

front beam screws holding them in place. 

Discard the braces and tighten the knobs 

and screws. 

2. 

Slightly loosen the black fold knobs 

on each side of the loom (Figure 1). 

Generally, a single turn will do.

 

Loosening the knobs all the way or 

removing them can cause the loom to 

collapse, which could result in injury. 

3. 

Stand at the side of the loom. Hold the 

front and rear beams together slightly. Pull 

the slide lock bars out toward the back of 

the loom. 

BEFORE YOU BEGIN

 

All Wolf looms assemble in a similar way. Watch the Baby Wolf assembly video on our 

Youtube channel (www.youtube.com/user/schachtspindle). 

 

You’ll find a complete labelled diagram of the Wolf loom in your Maintenance and 

Warranty manual and at schachtspindle.com.

 

Wolf loom legs are called out by where they cross each other. The legs that touch the 

ground at the front of the loom are called “inside” legs because they are covered by the 
“outside” legs when they cross at the loom center. 

 

The beater is at the front of the loom. The brake is on the right side of loom.

FL3001
FL3003
FL3011

FL3013
FL3021

 FL3023

FIGURE 1: UNFOLDING THE LOOM

slot in 

castle

FRONT OF 

LOOM

slide lock bar

shipping brace

front beam 
screw

fold knob

back beam 
knob

Reviews: