background image

4

3

2

1

Park vehicle on firm level ground, and turn off the
engine. Set the parking brake. Lay the chains out flat on
the ground, making sure there are no twists or tangles.
Make sure the cross chain hooks are facing upward.

Drape the chain over the tire, so that one cross chain is
postioned at the point where the tire meets the ground.
Again make sure the cross chain hooks are facing
upward. Hooks that face down (towards the tire) will
cause damage to the tire. 

Drive forward a few feet, far enoughso that one or two of
the cross chains pass under the tire.

Reach behind the tire and engage the inside connector
making sure it is as tight as possible. Then connect the
center (between the duals) fastener in the same manner.
See the illustration on the next page for a detailed look
at this connection.

Installation 

5

Next fasten the outside fastener, again making sure it
is as tight as possible. Drive a short distance and
retighten all fasteners. For best results, make sure all
connections are equal and as tight as possible.

Pg. 2

Summary of Contents for Quik Grip

Page 1: ...tant We strongly recommend that the chains be fitted to the tire prior to actual use to insure proper fit Tire sizes may vary because of age manufacturer tread or type Please ensure that the following points are correct when installing your chains 1 The chain should drape at least 3 inches over each side of the tire from the edge of the tread toward the rim 2 Check to make sure that you have the c...

Page 2: ... towards the tire will cause damage to the tire Drive forward a few feet far enoughso that one or two of the cross chains pass under the tire Reach behind the tire and engage the inside connector making sure it is as tight as possible Then connect the center between the duals fastener in the same manner See the illustration on the next page for a detailed look at this connection Installation 5 Nex...

Page 3: ...o be defective will be repaired or replaced Buyer shall not be entitled to recover any incidental or consequential damages No compensation will be made for any labor claim delays or damages incurred by using this product Although this warranty gives you specific rights you may have other legal rights which differ from state to state For more information please write to Security Chain Co Customer S...

Page 4: ...ury or vehicle damage Avoid speeds over 30 mph and use on bare pavements Chain links on cross members will be damaged and cause cross members to break Damage could occur to chains tires and vehicles Avoid spinning tires start slowly even in uphill conditions Avoid locking brakes the best braking technique is a pumping action If a cross member should break stop remove or replace it immediately Afte...

Reviews: